Re-indexed to ensure a factory quality ride. Made specific for each vehicle unlike mass produced torsion keys that sellers pass off as universal.Installation takes as little as 2 hours and can completed by any backyard mechanic. Once installed, your factory adjuster bolt can be used to set your desired ride height from 1"-3". DO I NEED ANY SPECIAL TOOLS FOR INSTALLATION? Yes, in order to install this kit on your application, you must use a Torsion Key Unloader/Puller. This is very similar to a gear puller which you can rent at any auto specialist store. We recommend either a 5 or 7 ton puller for this job.
HOW DO I ADJUST MY TRUCK FROM 1-3 AS STATED IN YOUR AD? Your factory adjuster bolt will allow you to personalize your front lift in order to put your truck up an exact amount. Our kit will give you about 2" of lift after installation, using the adjuster bolt, every full turn in either direction will increase or decrease your ride height 1/8". The best way to find out which kit you need is to measure from the ground to the top center of your wheel well in the front and in the rear.
Subtract the two numbers and that is the amount you need in order to level your truck. Heavy Metal reserves the right to make changes to the material, design, and specifications of the replacement item without prior notice.
The item "3 Front + 2 Rear Full Lift Kit Fits 1983-2005 Chevy Blazer S10 / GMC Jimmy S15" is in sale since Friday, September 21, 2018. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Suspension & Steering\Lift Kits & Parts".
The seller is "heavymetal-suspensions" and is located in La Mirada, California. This item can be shipped worldwide.